Motors

High-power 12 V brushed DC gear motors with integrated quadrature Hall encoder and 6-wire harness. Typical 37 mm-class gearbox with 6 mm D-shaft.

Brushless racing motor (2205 class) for 5" quadcopters, receives 3-phase power from AIO ESC.

14 mm stator outrunner brushless DC motor. 3800 KV, 9N12P configuration, 1.5 mm titanium-alloy shaft, NSK bearings. 9 x 9 mm M2 base mounting pattern. Nominally rated 2-4S; Project Stinger over-volts to 6S as a short-duty flywheel motor with aluminum-side-panel heatsinking.

N20 micro brushed DC gearmotor. 298:1 ratio, ~67–75 rpm at 6 V no-load, 2-lead terminals.

High-torque waterproof digital metal-gear servo (DS3225MG class) with standard 3-wire PWM control and 25T output spline.

High-power sensored brushless motor with dock interface and 1/2 in hex through-bore rotor.

Digital 30 kg·cm class metal-gear servo. Variants include 180°/270°/360° travel; standard RC PWM control; 25T spline.

No summary has been published for this part yet.

REV NEO Brushless Motor for FRC. Requires SPARK MAX or compatible brushless controller. Includes integrated hall effect encoder for position/velocity feedback.

Configurable metal-geared smart servo. 3-wire female PWM/power connector (GND/PWM/V+), rotating 25T spline output, and 4 mounting holes.

Sub-micro RC servo rated 180° travel. Standard 3-wire control, 4.8–6.0 V operation. ~9 g mass.

N20 micro gearmotor with quadrature Hall encoder and pre-soldered 100 mm JST-SH 6-pin cable. 31.5:1 ratio, 882 CPR at output shaft, 6–12 V operation.

Sub-micro analog RC servo similar in size/spec to Hitec HS-55. Includes single, double, four-point, and circle micro horns. Electrical: 3-wire RC servo. Mechanical: micro output spline (tooth count unspecified by baseline).

Short-body NEMA 17 bipolar stepper motor for extruders. 16 N·cm (22.6 oz·in) holding torque, 1.8° step, 1.0 A/phase, 4-wire.

NEMA 17 bipolar stepper motor, 59 N·cm holding torque, 1.8° step, 2.0 A/phase, 4-wire with 1 m cable and 4-pin connector.

9 g analog micro servo for RC and robotics. ~180° travel, 4.8–6.0 V supply, ~1.2–1.8 kg·cm stall torque depending on source.