Artifact Preview Pending
This part is available in the catalog, but no image or 3D asset has been published yet.
JST PH 6-pin Joiner Board - 4 Pack
Small pass-through PCB with two JST PH (2.0mm pitch) 6-pin connectors, used together with JST PH 6-pin Extension Cables (REV-11-1275) to extend NEO brushless motor sensor cables without cutting and splicing. Each of the 6 positions on connector A is wired straight-through to the corresponding position on connector B (1:1 on all 6 nets). The board carries the brushless motor's hall/encoder sensor signals, but REV does not document the per-pin sensor mapping, so the six nets are modeled as generic straight-through conductors (low confidence on individual signal names). Board is approximately 1 in (25.4 mm) long by 0.68 in (17.27 mm) wide. Sold as a 4-pack.
Category
Expansion Boards
Subcategory
Breakout Boards
Interfaces
JST Joiner
Domains
electrical
Summary
Small pass-through PCB with two JST PH (2.0mm pitch) 6-pin connectors, used together with JST PH 6-pin Extension Cables (REV-11-1275) to extend NEO brushless motor sensor cables without cutting and splicing. Each of the 6 positions on connector A is wired straight-through to the corresponding position on connector B (1:1 on all 6 nets). The board carries the brushless motor's hall/encoder sensor signals, but REV does not document the per-pin sensor mapping, so the six nets are modeled as generic straight-through conductors (low confidence on individual signal names). Board is approximately 1 in (25.4 mm) long by 0.68 in (17.27 mm) wide. Sold as a 4-pack.
Tags
Domains
electrical
Interfaces
JST Joiner